Interaction between the edging unit and trimming unit is made using the clamping arm, which has a working stroke of 2250 mm and is equipped with interchangeable vacuum plates for different size panels. The edging unit is equipped with a 2600 ml capacity glue pot installed on the top of the machine and is equipped with a heat retention device to reduce the waiting time for heating. While the glue roller drive and the panel drive are made by servo motor for fast and stable reaction. The panel driver allows for the auxiliary feeding of the panel through the glue and tape stations. The glue pot can be used for both EVA and PUR glue. A laser is used to detect tape position for consistent butt jointing when edging 360° geometries and has an accuracy of +/- 0.3mm. Anti-adhesion spray is applied automatically and controlled at two nozzles, for a cleaner result. A water based cleaner is recommended. The top and bottom trimming unit is made up of two high frequency motors running at 12,000rpm and are equipped with cutters that a capable of trimming both thin and thick edge including 2.0mm radius and 0.4mm bevel. Scraper are also fitted immediately after the cutter blocks for efficient scraping of the edge. Panel height and tool adjustment is manual. To avoid air starvation of the operating system, the machine has a built in 2 litre pressure vessel for air reserve. The machine is controlled from a touch screen that can be rotated 55° left and right for convenient operation. Up to 20 different programs can be stored and easily retrieved. The unit also allows for the manual control of o Power on/off of each unit o Glue temperature o Edgebanding speed o Edgebanding speed deceleration o Edgebanding length o Guillotine timing o Trimming speed o Trimming speed deceleration o Scraping